ZongshenForum.com
Zongshen Motorcycle, Scooter And ATV Forum

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - kutlassboyz

Pages: 1 2
1
Sportbikes / street fighter headlights
« on: December 27, 2009, 07:13:21 AM »
streetfighter headlights many in stock, custom weldng, and seats
all headlights $40.
want it today get it today.
i can make your stock muffler into a custom stubby, frame cutting and welding.
we can work together to build your dream streetfighter


Location: miami 125th and biscayne
zongshen kawasaki honda suzuki ktm
email kutlassboyz @yahoo.com
ebay: http://stores.ebay.com/kutlassboyz-streetfighter-supply-of
craiglist: [img]http://miami.craigslist.org/mdc/mcy/1525931086.html

2
Sportbikes / Re: At high rpms bike boggs and back fires...
« on: December 01, 2009, 04:40:14 AM »
there is a filter on left and right side of engine. during break in u will have metal flakes as prts are wearing down and meshing with each other. clean both filters. ( read your manual) ::) . breather was a smart move. but it is bogging because you have too much oil. also look under air filter box and there is a lil clear bulb. if it had oil in it from BEFORE you put the breather on, empty it out too.

3
Sportbikes / Re: cannot shift to 1st ....clutch problem
« on: December 01, 2009, 04:34:02 AM »
actually the fork a in tranny had broken off a tooth. new tranny was $80. im ridin

4
Sportbikes / cannot shift to 1st ....clutch problem
« on: November 07, 2009, 03:17:44 AM »
shifts through all gears fine. out riding would not go into 1st. will shift into 1st after adjustment of clutch and/or clutch play but after riding a block or so will not go into 1st again. any ideas?

5
Sportbikes / Re: New bike problem
« on: November 07, 2009, 02:53:12 AM »
make sure oil level is correct. if its not that then also adjust idle air screw on carb. take note of its position and how much you turn it so you can put it back if necessary. from all the way in it should be between one and 2 and a half turns out. you probably have too much oil though. i wouldnt take the carb apart just yet,

6
Sportbikes / Re: idles shuts off with any throttle help!!!!!!!!!!!!!!
« on: October 30, 2009, 09:02:04 PM »
yeah i added inline fuel filter and i just got ascerbis headlight and fairing. just did valve adjustment too. running smooth.

7
Sportbikes / Re: Need help. Wont start with ignition
« on: October 18, 2009, 06:00:36 PM »
clicking is probably battery or starter not gbetting power from battery. stator probably bad though. same thing happened to me

8
Sportbikes / Re: Some info please..
« on: October 18, 2009, 05:58:03 PM »
it came with tk but i have a raptor on it now. the float moves up and down it should be 15-16mm from top (you will have carb upside down so it will seem like bottom) of bowl u can use a ruler or mark a toothpick unless it sat with gas in carb or u have dropped it the float is usually ok. but it should only move a cm and a half or so either direction.

9
Sportbikes / Re: idles shuts off with any throttle help!!!!!!!!!!!!!!
« on: October 18, 2009, 05:54:20 PM »
bike is fixed and running well now,  cleaned tank with baking soda and electrolysis ( connectec battery and floated coat hangar) cleaned filters on bith sides of engine, added breather,. about speeds i run my bike 1) i am only 140 lbs and 2) i have casoli no rev limit cdi and ss coil, and raptor carb.3) i live in south fla the atmospheric pressure here allows me to run more fuel and higher speeds with my jet and airflow setup. my valves are beautiful and that wouldnt cause bog down,anyway. somewhere the mixture was being thrown off i believe it was the rust in my tank and a filthy filter on right side of engine. im back to haulin ass i did 80 all the way to pompano and it was cold last night so i had throttle left to spare.

10
Sportbikes / Re: Some info please..
« on: October 16, 2009, 10:53:04 PM »
autopart store will have gauge but if there is a motoshop near u they will have a better one cyclegear will have it cheaper than a mom n pop

11
Sportbikes / Re: where to buy the cdi
« on: October 16, 2009, 07:15:10 PM »
call manny at zongshen in miami 305 500 9989 tell him tony sent u

12
Sportbikes / Re: Some info please..
« on: October 16, 2009, 07:12:59 PM »
float height per manual is 16-15 mm anything else must be repaired

13
Sportbikes / streetfighter mod zong 250 cruiser light on sportbike
« on: October 16, 2009, 07:02:26 PM »
10 bucks from zongshen warehouse in miami, much cheaper than any other streefighter kit ive seen.
mounted to brake fluid dispersiion valve  between forks with 6 inches of drop ceiling hangar from home depot. its thick and rigid and comes with holes down lenth of metal, very difficult to bend. 1.99 for four feet used exisiting bolt between valve and frame and existing screws on light. no drilling or cutting

14
Sportbikes / Re: idles shuts off with any throttle help!!!!!!!!!!!!!!
« on: October 16, 2009, 06:48:30 PM »
when i started this problem oil was black in airbox bulb. i changed it and it is at correct levels. still will not run. will run briefly after cleaning carb then starts to sputter and cough out. drained gas tank again and looked inside. extreme rust. believe it is clogging carb. going to put breather on engine and uni. pod filter like i did on my enduro and get new gas tank on mon. seen hundreds of posts with same problem. the amount of rudst is startling. bike was assmbled less than a year ago only has 1200 or so miles i ride it 50 miles each way about once a week. and went out of town for a couple of weeks. was running great when i left. i run 80 plus mph at 1100-1200 rpm ( i weigh 140) even going uphill. has anyone had oilover flow stop throttle from stand still? i know it can shut bike down at high speed (has happened to me ) even if oil level is correct.

15
Sportbikes / Re: ZS250GS Custom Street Fighter
« on: October 16, 2009, 06:23:37 PM »
is that original headlight with modified orion front faring?

Pages: 1 2

An Error Has Occurred!

Call to undefined function split()
Back